If the concrete pavement is constructed, there will be some very fine streaks, and when the concrete is not dry, there will be some uneven pavement, becides, after the concrete pavement has been used for a long time, the surface of course will become old, and may sand or crack,  In this case, the protruding surface needs to be polished to flatten the protruding part or floor renovation.

Based on cost and some applicability considerations, people need to pay attention to several aspects of the segment when using concrete abrasives, Knowing that these can save a lot of costs, but also improve the efficiency of concrete grinding.

It is necessary to choose a reasonable grinding segment according to the hardness of the concrete material. Generally speaking, ordinary  segment can already meet most of the needs of concrete grinding, but if the concrete surface is extremely hard or extremely soft, this will make you can’t cut off or cause diamond segments wear out too fast. Therefore, base on the concrete hardness, we customize diamond segments into several bonds-Soft, medium, hard. Soft bond for hard concrete, medium bond for medium hard concrete, hard bond for soft concrete.

Diamond Segments can be used for both dry grinding and wet grinding. For Dry Grinding, it will not produce sewage while concrete grinding, but you need to equip industrial vacuum cleaners for your floor grinders, or there will be dusty, make your operator feel disgusted, and also not good for there health. For wet grinding, not only it can appropriately improve the aggressiveness of segment, but also reduce the flying of dust. The disadvantage is it will produce a lot dirt water, it’s troublesome to deal with. In terms of noise, it is much smaller than the huge noise caused by dry grinding.

Diamond Segments are made of diamonds of various particle specifications such as large, medium, and small particles. The most common ones are 6#, 16/20#, 30#/40#, 50/60#, 100/120#, 150#. The large particles of diamond, the effect has higher requirements. Gradually increase the mesh number to allow the particles to be used from large to small, which will gradually grind the concrete very flat. In the process of use, do not use fine-grained diamond segment for grinding at the beginning, because there is no large-grained segment for rough grinding, and direct fine grinding will cause the segment to consume too quickly, and the grinding effect will not be achieved.

In the process of concrete grinding, the requirements for machinery are very high. If the machine is old, it is easy to over-grind during the grinding process. In many cases, it is up to people to feel the depth and thickness of the grinding. Such an approach will undoubtedly cause the cutter head to be consumed too quickly, and the road surface will also appear uneven.

In general, diamond segments for concrete grinding needs to be specially customized to balance the life and wear resistance.